XT-HDBT-MX44-4K-KIT
USER MANUAL
www.xantech.com
®
RS-232 and Telnet Commands
The Matrix can be controlled via serial and TCP/IP. The following pages list all available serial commands for the Matrix.
Details of RS-232 pin assignment can be found on the previous page.
Commonly used Serial commands:
There are several commands that are commonly used for control and testing:-
STATUS
Status will give feedback on Matrix such as zones on, type of connection etc
PON
Power on
POFF
Power off
OUTxxON
(xx is the zone number you wish to turn on)
Example:-
OUT01ON (This would turn output one back on)
OUTxxFRyy
(xx is the zone out, yy is the input)
Example:-
OUT01FR04 (This would switch output 1 to source input 4)
Common Mistakes
• Carriage return – Some programs do not require the carriage return where as other will not work unless sent directly after the string. In the
case of some Terminal software the token <CR> is used to execute a carriage return. Depending on the program you are using this token maybe
different. Some other examples that other control systems deploy include \r or 0D (in hex)
• Spaces – Blustream commands do not require space between commands unless specified. There may be some programs that require spacing
in order to work.
- How the string should look is as follows OUT01ON
- How the string may look if spaces are required: OUT{Space}01{Space}ON
• Baud rate or other serial protocol settings not correct
RS-232 COMMAND
DESCRIPTION
?
Print Help Information
HELP
Print Help Information
STATUS
Print System Status And Port State
PON
Power On, System Run On Normal State
POFF
Power Off, System Run On Power Save State
IR ON/OFF
Set System IR Control On Or Off
KEY ON/OFF
Set System Key Control On or Off
BEEP ON/OFF
Set System Deep On Or Off
LED ON/OFF
Set Front Panel LED Always On
Or Auto Turn Off In Power On State
RSB X
Set RS-232 Baud Rate to X bps
x=[0:115200, 1:57600 2:38400, 3:19200, 4:9600, 5:4800]
RESET
Reset System To Default Setting
RESET ALL
Reset System And Network To Default Configuration
(Should Type “Yes” To Confirm, “No” To Discard)
OUT xx ON/OFF
Set Output:xx On or Off
OUT xx FR yy
Set Ouput:xx From Input:yy
xx=00: Select All Output Ports
xx=[01...04]: Select One Output Port
yy=[01...04]: Select One Input Port
POH xx ON/OFF
Set Output:xx POH On Or Off
xx=00: Select All Output Ports
xx=[01...04]: Select One Output Port
yy=[01...04]: Select One Input Port
