ISM4 INSTALLATION & PROGRAMMING MANUAL
29
APPENDIX
NAVIGATING AND EDITING MACROS
The six Front Panel Buttons each have multiple functions, depending upon the ISM4 Mode. The following
sections detail those functions within the different modes. An understanding of the button presses will help make
the programming process easier. For the actual programming instructions, see Section:
Programming Macros
.
Normal Operating Mode
In Normal Operating Mode the Front Panel Buttons are typically not used. They are used in this mode to clone a
new ISM4 and to enter Edit Mode.
Figure 9 Front Panel Navigation – Normal Operating Mode
PREV
In
Normal Operating Mode
, press for
2 seconds
(Indicated by the first blink of the Active Source
LED) to initiate the
Macro Table Clone Process
. This will transfer the programming from one ISM4
to another.
Macro Table Clone
requires that both units are properly connected via their
RS232
Ports
.
All Source LED’s
will rapid flash green during the Macro Table Clone Process.
SEQUENCE
In
Normal Operating Mode
, press for 2
seconds
(Indicated by the first blink of the Active Source
LED) to put the ISM4 into
Edit Mode
. By default, the
Source 1
and
Program LED’s
will illuminate
green
to indicate
Edit Mode
.
In
Normal Operating Mode
the
other
Front Panel Buttons
have
no functions
.
In
Normal Operating Mode
, a
Source LED
will illuminate solid
green
when the associated Sense Input ‘sees’ a
Sensor Control Voltage from a connected Sensor Module when the sensed source is ON and turn off when the
Sensor Control Voltage is cut when that same source is OFF.