ISM4 INSTALLATION & PROGRAMMING MANUAL
15
6.
Using a
Xantech 10-Foot Mono Cable
(Xantech Part No 06017450) connect the
Common “IR Out “
on the
multi-zone controller to the
IR Control Jack
on the
ISM4 Rear Panel
. This will allow IR control of the ISM4
and pass through of IR commands from the multi-zone controller to the source devices.
7.
There is no required emitter connection to Source 1 in this application.
8.
Label the Sensor and Common IR wires for reference.
Source 2 (DVD Player)
10.
Using a shielded
male to male RCA-RCA video cable
(Composite Video Cable) with gold ends, connect the
Composite Video Output
of the
DVD Player
to the
SMVID01 RCA sensor head
.
11.
Either plug the
sensor head
directly into the
multi-zone controller DVD Composite Video Input
or connect
a shielded
female to male RCA-RCA cable
with gold ends to the
sensor head
and then to the
multi-zone
controller DVD Composite Video Input
.
12.
Plug the
SMVID01 3.5mm mini plug
into the
ISM4 Source 2 “Sense In” Jack
.
13.
Turn the
DVD Player
ON. The
SMVID01 Status LED
should illuminate
red
. (The Source 2 Status LED on the
ISM4 Front Panel should also illuminate solid green. For now, disregard any other front panel LED activity.)
14.
Turn the
DVD Player
OFF. The
SMVID01 Status LED
should turn
off
. If it does not turn off, adjust the
sensitivity
to the point where the
Status LED
turns
off
. (The Source 2 Status LED on the ISM4 Front Panel
should also turn off. For now, disregard any other front panel LED activity.)
NOTE:
Some devices have a constant signal output on the composite video output jack (many cable boxes
and other devices) and are not compatible with video sensing. If adjusting the sensitivity on the SMVID01 with
the DVD player (or other device) OFF does not turn the Status LED OFF, another sensing method must be
used, such as a switched outlet on a cable box as shown in
Figure 6
.
15.
Remove the
protective backing
from an
IR Emitter head
. Carefully attach the emitter over the
IR eye
of the
DVD Player
. If the eye is not obvious, shine a small flashlight into the faceplate to locate it or refer to the
product manual.
16.
Carefully pull the
emitter wire
to the back of the DVD Player and over to where the
ISM4
is located. Be
careful not to pinch the wire between components or block the disc drawer.
17.
Plug the
Emitter 3.5mm mini plug
into the
ISM4 Source 2 “IR Out “Jack
.
18.
Label the sensor and emitter wires for reference.
Source 3 (Cable Box)
Follow the instructions for
Source 1
(A/V Receiver), for
voltage sensing
. The
switched outlet
on most cable
boxes must be configured in the
Cable Box Setup Menu
. Be sure the
AC Convenience Outlet
is set to:
Switched
.
Source 4 (Video Recorder)
Follow the instructions for
Source 2
(DVD Player), for
video sensing
.