Model IR-X10
Page 11
© 2002 Xantech Corporation.
SCENES SETUP
Before scenes can take effect when executed, a special
Scene Setup
set of
codes must be issued first. This instructs each X10 module (an X10
requirement) to accept the Scene Module Level settings when sent later in a
Macro. This only needs to be sent the first time being used or any time any
of the X10 modules have been disconnected from the AC source or after
Power Outages.
There are two methods of issuing these commands.
1. Place
the
Scene Setup
command on a dedicated button on the remote.
When used for the first time or after power outages of any sort, select
this button to issue the scene command and then continue to select any
Macro containing a
Scene Cmd
(
Scene Cmd
explained in the next
section). If a dedicated button is not available (all commands on
controller used), use method #2.
2. Place
the
Scene Setup
into a Macro following a ‘preferred’
Scene Cmd .
This will save a button from only being used in Power Outages and
place the
Scene Cmd
into a frequently used X10 Scene Macro. First
time used, or after power outages, select this button twice (once to issue
Scene Setup
and second time will execute the desired
Scene Cmd.
)
Method 2 will be described in the Programming an X10 Scene Macro
section, Step #5.
Note:
You can also program a
Scene Setup
into
Tier 2
of your controller.
This way, after a Power Failure or first time use,
Push & Hold
the Tier 2
programmed button for more than 1 second to issue the
Scene Setup
.
Please see your Dragon Drop-IR manual for further information
regarding programming
Tiered
functions.
Creating a Scene Setup via Method One:
1. Click Scenes Setup from the Function List Box.
2. Click a button on the URC-2P/B not used for any other function in your
IR controlled system (e.g., the D button in the lower section of the URC-
2P/B remote).
3. Click Place from the Function section. A special set of commands will
be placed under the selected URC-2P/B button. Option: To make this
button accessible under any Source Bank, right-click this URC-2P/B
button and then left click Punch.
CAUTION
: Every time you make a change in Scene Programming, you
must perform a new Scenes Setup procedure by repeating steps 1 through
3. Be sure to delete the old command set before placing the new one on the
controller.
