XAG V40, Pilot Operating Handbook

Page: 34 / 122

XAG AUSTRALIA 34
01
LED – Battery Level Indicates the Battery Level of the Remote Controller
02
LED – Smart Device Status Indicates whether the remote controller is connected to Smart Device
03
LED – Device Status Indicates whether the remote controller is linked to the Aircraft
04
LED – Control Mode Indicates the Flight mode of the Device (Manual / Autonomous)
05
LED – Terminal Status Indicates whether the remote controller is connected to Terminal
06 LED – RTK Status Indicates the RTK Status of the Remote Controller
07
Heat Sink Used to dissipate heat from internal Components
08 Spray/ Increase the rate of Spray / Spread
09
Spray / Spread Button Press to Enable / Disable Spray or Spread
10 Spray/Spread – Decrease the rate of Spray / Spread
11
Speed + Increase Speed
12 Speed Broadcast Button Press to broadcast the current Speed
13
Speed – Decrease Speed
14 Button A Mapping Mode: Add Point
15
Smart Mode Button Long Press to Enter / Exit mapping Mode
16 Button B Mapping Mode: Undo previous Added Point
17
Yaw Control – Left Rotate Device CCW (Counter-Clockwise)
18 Yaw Control – Right Rotate Device CW (Clockwise)
19
Terrain Button Used to Broadcast and Turn ON/OFF Terrain Following
20 RTH Button Press and Hold this RTH button to initiate Return to Home (RTH)
21
Directional Control – Forward Press and Hold to command the Aircraft to fly Forward
22
Directional Control – Sideway Right Press and Hold to command the Aircraft to fly Sideway to the Right
23
Directional Control – Backward Press and Hold to command the Aircraft to fly Backward
24
Directional Control – Sideway Left Press and Hold to command the Aircraft to fly Sideway to the Left
25
Hover Button Press to Hover or Long Press to resume Autonomous Operation
26
Power Button Used to turn ON/OFF the remote controller
27
Nano SIM Slot Provides Cellular connection
28
Al Increase Altitude
29
Altitude – Decrease Altitude
30
Power Port Connects to a power source to charge the Remote Controller