XAG V40, Pilot Operating Handbook

Page: 104 / 122

XAG AUSTRALIA 104
Pre-Flight Checklist
Aerial Flights
01
Inspect and ensure the propellers are Clean and in good condition (DO NOT use aged,
chipped, damaged or stained propellers).
02
Inspect and ensure the correct Propeller are installed on each Arm.
Right Arm – CCW Propeller Left Arm – CW Propeller
03
Inspect and ensure the batteries, liquid tank, and the Motor is properly secured.
04
Inspect and ensure the integrity of the Airframe.
05
Check & ensure Firmware & APP is up-to-date
06
Check and ensure there are sufficient battery for the operation (Including LNT, Remote
Controller and RTK Station Battery).
07
Check and ensure the Remote Controller is paired to all aircraft, and ready to operate
the aircraft and manually avoid obstacles promptly or during an emergency.
08
Check and ensure the Communication is Normal
√ RPA enters RTK Mode
√ RPA Heading Accuracy < 2º
√ Number of Satellites > 16
09
Spray / Spread System had been calibrated and tested
10
Perform Motor Test to ensure it is operating normally, and Tilt Servo Calibration is
balanced.
11
Clean and ensure the cleanness of the Dynamic Radar, PSL Camera and Terrain Sensor.