1.
B
EFORE
S
TARTING
Open the gate behind the device (Figure 1), and find the power input on the right side of the terminal. Connect the
plug from the power adapter into the power input (Figure 2). Plug the power adapter into a 120-volt electrical outlet
or into a surge suppressor (recommended) after the power cord is connected to the power adapter.
Figure 1 Figure 2
Operating Temperature: 0
C to 40
C
Modem Speed: V.22bis 2400bps/ V.32bis 14400bps
RTC battery spec. : 3V, CR2032
Adapter: HON-KWANG, HK-AX-120A200 -WW (WW = EU, US represent the different plug types), I/P:
100-240Vac, 50-60Hz, 0.8A, O/P: 12Vdc, 2.0A
Adapter (Alternate): Delta Electronics Inc, ADP-36PH B, I/P: 100-240Vac,50-60Hz, 1A,O/P: 12Vdc,3.0A, LPS.
* Power Adapter: DC 12V, 2A or 3A(Output Rating)
(Use only the XAC Automation Corporation provided AC adapter approved for use with this device. Use
of another AC adapter may cause a fire or explosion)
Caution:
The cover (Figure 5) shall be provided with a means to keep it closed during normal operation.
Caution:
Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used battery according to the instructions.
Warning:
A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby
radio and television reception. It is essential that only the supplied power cord be used.
Connect one end of the phone cord into one of the jacks on the back of the terminal (Figure 3). Plug the other end of
the cord into a modular wall jack (Figure 4). Use only a jack for an analog line like a fax line or a standard telephone.
Figure 3 Figure 4
(Optional) This terminal supports three USB ports. Two USB host ports locate on the back of the terminal (Figure 5). One USB device
port locates on the left side of the terminal (Figure 6). If the terminal uses a peripheral device with USB connector, plug it into the USB
host port.
(Optional) This terminal supports one RS-232 ports of RJ-12 offset keyed connector. If the terminal uses a peripheral device with this
type of connector and interface, plug it into the RS-232 port on the back of the terminal (Figure 7).
(Optional) If the terminal needs communication over Ethernet, plug cable into the RJ-45 port on the back of the terminal (Figure 8).
Figure 5 Figure 6
Figure 7 Figure 8
2.
P
OWER
O
N THE
T
ERMINAL
Plug the power cord into the power jack and plug the power adapter into a 120-volt electrical outlet or into a surge
suppressor (recommended) after the power cord is connected to the power adapter. T103LE would start to boot
automatically.
