28
29
When selecting the installation site, consider the room conditions, meaning the location of the
next outlet, etc. Also prevent direct sunlight, vibrations, dust, heat, cold and dampness. Keep the
appliance away from strong transformers or motors.
Operate the device only on a stable, level surface. There must be enough space
around the system for air circulation to permit dissipation of the generated heat.
Therefore, only place the device on a level surface and not on carpets, etc. Do not
cover up the ventilation slots in the casing.
If you do not heed these instructions, the device may be damaged.
Do not drill extra holes or screw any extra screws for mounting purposes into the
case. This will damage the device.
Only operate the CD player in a horizontal position, otherwise it will not function
properly. If you do not heed these instructions, the inserted CD or the CD player may
be damaged.
Make sure you position the appliance in a safe and stabile place, away from objects
that might fall on it, thereby avoiding unwanted accidents.
Because of the variety of used lacquers and polishes for furniture, the device base might leave
residues on furniture due to a chemical reaction. That‘s why do not place the device without
appropriate protection on the valuable furniture surfaces.
3
Setup
Chapter 4
Connection
Chapter 3
Setup
Make sure that, before you connect the device, it is disconnected at the mains. Si-
milarly, all other devices to be connected should be separated from the electricity
supply.
Pay attention to connect property, that is, left always to left and right always to right.
Connection of the cinch outputs and the remote control cable
For the connection of the cinch sockets only use the shielded cinch wires. The use
of other cables might cause interference. To avoid distortion or mismatching which
could damage the device, only devices which also have cinch outputs may be con-
nected to cinch inputs.
To connect the remote control depot, use only the cables included.
The white cinch socket is connected with the left cinch socket of the amplifier.
The red cinch socket is connected with the right cinch socket of the amplifier.
4
Connection
E Q
TA P E
TU NE R
C
E
R
Y
A
L
P
R
E
N
U
T
D
C
O
N
O
H
P
TA P E
PL A Y
R E C
EQ
CD
L
R
RE M O T E S Y ST E M
_
A U D I O
L
RI G H T
L E F T
_
AV 1
AV 2
L
R
IN T E G R AT ED C IR C UI T
A C 2 20V - 23 0V ~ 50H z
S P E A K E R S 6 ~ 8
GND
OU T P U T
R E M O T E SYSTEM
T O A M P
C D P LAY ER
IN TE G RAT ED C IR C U IT
AC 2 20 V~ 50 Hz
PO W E R CO N S U M PT IO N 1 0W
CD
