User Manual
OABR2CAN
16
Select a message and click
to add this message to the routing table.
Repeat this step for up to 255 further messages if required.
or
Click somewhere in the message list, then
and
Yes
to route all messages of the
interface unfiltered.
or
Click somewhere in the message list, then
and
No
to add all messages from the
list (max. 256).
The number of routed messages is displayed in the table column
Info
.
Target IP
If the sending interface is OABR, so
Ethernet 1
or
Ethernet 2
, then specify
the
Target IP
that can also be a multicast address. This setting is saved for
every message individually.
Click to create further interface mappings if required.
Click
to save the configuration.
Navigate to the target directory and specify a
File name
.
Click
Save
.
Connect to gateway
Before you connect the gateway in the software, you must activate the USB bootloader
mode:
Make sure that the correct USB driver is installed.
Connect the gateway to the power supply (see chapter
Connecting
).
Turn on the power supply.
Connect the gateway via service interface
(C)
to your PC.
Press the reset button
(H)
with a pointed object.
The gateway indicates USB bootloader mode by yellow illumination of the LEDs
(A)
and
(F)
.
Click
to connect to the gateway.
An established connection is indicated by a blue border around the icon:
Summary of Contents for OABR2CAN
Page 1: ...OABR2CAN Media Gateway User Manual Version 1 8 November 2019...
Page 21: ......