1 1
1 1
1 1
1 1
1 1
1 0
1 0
1 0
1 0
1 0
TTTTT
HE
HE
HE
HE
HE
UR78A R
UR78A R
UR78A R
UR78A R
UR78A R
EMOTE
EMOTE
EMOTE
EMOTE
EMOTE
The UR78A Remote lets you control practically every audio/video
product in your home. It has IR technology that lets you control your
TV, VCR, Cable and CD or DVD player, and RF technology that lets
you control the VR32A wireless receiver/speaker driver. This lets
you control, the volume, balance, bass, treble, etc. of the speakers
connected to the VR32A from anywhere inside or outside your home.
It can also control an MP3, DVD, and CD player in your PC when
used with an additional RF receiver and software (see page 17).
IIIII
NST
NST
NST
NST
NSTALLING
ALLING
ALLING
ALLING
ALLING
THE
THE
THE
THE
THE
BA
BA
BA
BA
BATTERIES
TTERIES
TTERIES
TTERIES
TTERIES
1.
1.
1.
1.
1. Push the tab and lift off the battery cover.
2.
2.
2.
2.
2. Insert four AAA alkaline batteries, taking
care to match the + and - marks in the
battery compartment.
B
BB
BB
A
A
A
A
ATTER
TTER
TTER
TTER
TTERY
YY
YY
S
S
S
S
S
A
A
A
A
AVER
VER
VER
VER
VER
Your UR78A remote will automatically “time-out” if the keys are
depressed for more than two minutes. This will save your batteries
should your remote get stuck in a place where the keys remain
depressed (e.g., between the sofa cushions).
C
CC
C
C
ODE
ODE
ODE
ODE
ODE
S
S
S
S
S
A
A
A
A
AVER
VER
VER
VER
VER
(I
(I
(I
(I
(I
MPOR
MPOR
MPOR
MPOR
MPORTTTTTANT
ANT
ANT
ANT
ANT
)))))
You will have up to 90 seconds to change the batteries in your
remote without losing codes you have programmed. However, do not
press any buttons until batteries are installed in the remote. If buttons
are pressed without batteries in the remote, all codes will be lost.
IIIII
FFFFF
YOU
YOU
YOU
YOU
YOU
ARE
ARE
ARE
ARE
ARE
NOT
NOT
NOT
NOT
NOT
GETTING
GETTING
GETTING
GETTING
GETTING
ANY
ANY
ANY
ANY
ANY
SIGNAL
SIGNAL
SIGNAL
SIGNAL
SIGNAL
A
A
A
A
ATTTTT
ALL
ALL
ALL
ALL
ALL
Check that the CHANNEL slide switch (labeled A, B, C, D) on both
units is set to the same letter.
IIIII
FFFFF
THE
THE
THE
THE
THE
SIGNAL
SIGNAL
SIGNAL
SIGNAL
SIGNAL
IS
IS
IS
IS
IS
POOR
POOR
POOR
POOR
POOR
, , , , ,
OR
OR
OR
OR
OR
THERE
THERE
THERE
THERE
THERE
IS
IS
IS
IS
IS
INTERFERENCE
INTERFERENCE
INTERFERENCE
INTERFERENCE
INTERFERENCE
Try changing the channel on both units. Do this by adjusting the
CHANNEL slide switch on each unit to any position from A to C.
Make sure both units are set to the same channel.
F
F
F
F
F
INE
INE
INE
INE
INE
T
T
T
T
T
UNING
UNING
UNING
UNING
UNING
YOUR
YOUR
YOUR
YOUR
YOUR
S
S
S
S
S
YSTEM
YSTEM
YSTEM
YSTEM
YSTEM
The Wireless Audio Sender usually works best with the flat faces of
the antennas on the Sender and Receiver units facing each other (i.e.
in “Line of sight” - see diagram below). Sometimes, however,
reflections and other effects in your home may affect the signal so
that some adjustment of either the Sender or Receiver antenna might
be necessary to get the best signal.
