29
28
SOLUTION
PROBLEM
If you do not hear a beep from the
Console when you press
TEST
to install
a Door/Window Sensor or Motion
Sensor.
With the Console in the RUN 2 mode,
check that it chimes when you press
TEST
on the Door/Window Sensor, or
the zone indicator for a Motion Sensor
blinks. If it does, then sensor is already
installed and no further action is
necessary. If not:
1. Check that the Console is set to the
INSTALL
mode.
2. Change the code on the sensor (see
Setting Up Door/Window Sensors and
Setting Up Motion Sensors.
If the battery indicator on the Console
is on.
Replace the console's batteries. Four
AA alkaline batteries provide
approximately 12 hours of backup.
Replace batteries at least once a year.
If you lose your remote control.
Reinstall your complete system to
prevent someone else from using the
lost remote control.
If the system Arms or Disarms by itself
A neighbor might have a compatible
system. Reinstall the complete system
so that it chooses different RF codes.
If the red light on the Remote Control
stays on during installation.
Press
CODE
then press
ARM
. If it still
stays on, remove the batteries, wait a
few seconds, then replace the batteries.
Press
CODE
then press
ARM
again.
SOLUTION
PROBLEM
You open a door or window and the
alarm does not trip.
• Check that the system is armed.
• Be sure the slide switch under the
SETUP flip door is in the
RUN1
or
RUN2
position.
• Check to see if the alarm trips when
you press
TEST
on the Door/Window
Sensor.
• If the alarm does not trip when you
press
TEST
, check that the indicator
on the sensor comes on when you
press
TEST
.
If the indicator does not come on,
replace the batteries and reinstall the
sensor if necessary.
If appliances turn off during an alarm.
The system flashes lights by repetitively
transmitting A-13 on/off. Therefore any
appliances (connected to Appliance
Modules set to A-13) which were on at
the time of the alarm will turn off.
If you do not want this to happen, set
the Appliance Module(s) to a different
Housecode from the one you set on the
Console.
If you do not hear a beep from the
Console when you press
ARM
to install
a Remote Control.
Check to see if you can arm the system
when the Console is in the
RUN
mode.
If you can, the Remote Control is
already installed and no further action
is necessary. If not:
1. Check that the console is set to the
INSTALL
mode.
2. Re-initialize the remote (see page 8
- Setting Up Remote Controls).
All manuals and user guides at all-guides.com
