X-Tronic 4040-XTS, Instructions Manual

Page: 7 / 16

- 5 -
WARNING
You must remove the 2 red screws on the bottom of the machine
mentioned in Step 2 before using the unit. Failure to follow this
precaution could result in undesired results and harm your unit!
PRODUCT SET UP
1. Unpack all of the contents of the X-TRONIC # 4040-XTS Kit.
2. Remove the 2 Red screws from the bottom of the main unit.
NOTE: Failure to complete this step could result in permanent
damage to the unit!
3. Plug the soldering iron into the correct connector and secure it using
the attached nut.
4. Attach the hot air gun holder to the side of the main unit using the 2
included screws.
5. Place the hot air gun into the holder before applying power to the
unit.
6. Ensure all connections are secure and the fuse in the rear of the unit
is in good working order before applying power.
7. Plug in the power cord to a GROUNDED AC wall outlet.
8. Select the proper unit of temperature measurement to be displayed
(°C – °F) using the slider switch located between the temperature
displays on front panel.
9. Turn the unit on.
a. Soldering Iron
i. Turn on the soldering iron power switch located on the front of
the machine.
ii. Adjust the temperature to the desired value using the
Sol-Temp Set knob located at the bottom center of the front
panel.
NOTE: See maintenance section for proper setup, use and
cleaning of the solder iron tip.
b. Hot Air Gun
i. Attach the desired nozzle to the hot air gun.
ii. Turn on the hot air power switch located on the front of the
machine.