General Instruction Before Riding
1) Tire check - Check the tires for correct inflation pressure and for any signs of physical
damage.
2) Brake check - Squeeze the brake lever (Front then Rear) as hard as you can, push the
scooter forward and check the braking resistance.
3)
Safety Circuit Breaker
(P. 5) When the key is inserted and turned to the ”ON” position, the
power indicator will illuminate. If instant current is over 100A, the power will be automatically cut
off to avoid over-heating and damage. Wait for one minute and then reset the circuit breaker
located under the seat to restart your scooter. This circuit breaker is switched off before delivery,
please switch on before riding.
4) Battery Check - Make sure your scooter is sufficiently charged and always check the battery
gauge while you are riding and be sure that it does not get too low too often.
5) Steering - Inspect the handlebar for any damage. Apply the front brake and push the
handlebar up and down to check for any unusual noises. Move the handlebar in all directions to
check for any loose parts or obstructions. Any problems should be corrected before use.
6) SAFETY NOTICE
6.1. To prevent the scooter moving away unexpectedly, always turn the key to the “OFF”
position before dismounting or leaving the scooter unattended.
6.2. Always engage the rear brake when mounting or dismounting the scooter. Ensure that
you are seated on the scooter and check that the stands are clear of the ground, before touching
the throttle. If you twist the throttle before you are ready to go or while you are mounting the
scooter it may move away from you and could lead to an accident.
7) Water and Cleaning - Your scooter can be ridden in wet and rainy conditions. When riding in
rain, do not ride through deep puddles or muddy areas as excessive water will cause the motor
and other electrical components to suffer damage. During cleaning, as with any motor vehicle, be
sure to avoid soaking any electrical component during cleaning to avoid serious damage.
NEVER USE A HIGH PRESSURE WASHER WHEN CLEANING THE BIKE
.
8) Parking - Your scooter should not be left in strong, direct sunlight or heavy rain for extended
long periods as this will prematurely age and damage paintwork and the general finish of the
scooters appearance and some of the electric components may overheat.
9) Riding - Never overload and ride your scooter. Prolonged use with excessive weight could
cause serious damage to the electronic and mechanic parts and void your warranty. It is
recommended that all new scooter riders enroll in rider training for safety reasons.
10) Road Rules - As with any vehicle, a scooter rider must always comply with the local road
traffic rules and regulations. Before taking your scooter out on a public road, make sure you are
familiar with traffic rules and regulations and any special requirements for motorcycles & scooters.
11)
Never drink and ride
- Alcohol slows reflexes and greatly limits your ability to operate a
scooter. Even a very small amount of alcohol will reduce your ability to operate a scooter safely.
Summary of Contents for XM-4000Li
