Page24
throttle snapped open.
Alternative Method:
1.) Run the motor full throttle and adjust slowly until you achieve max rpm.
2.) Give a 1/4 turn counterclockwise to provide just a little rich and ride scooter.
How To Change Charger Socket
1.) Locate the rear of the charging socket.
2.) Follow wires and disconnect white plastic connector from controller.
3.) Remove nut on back of charger socket.
4.) Look down inside the connector; you will see the two metal pins. They are held in
place by a small tab that bends outward. Reach inside the front of the connector with
a dental pick or jeweler
’s screwdriver and bend the tab in then pull the metal pin out
the back of the connector.
5.) Install the new charging socket and secure the nut.
6.) Reinsert the wires into the white connector making sure to match red-to-red and
black-to-black in the connection.
7.) Test new charger socket with charger.
8.) Re-assemble.
How To Remove Free Wheel Clutch
To remove your free wheel you must first remove the rear wheel from the scooter then
proceed to the directions below.
1.) Remove the sprocket from the free wheel.
2.) Place penetrating oil (WD-40) where the free wheel and wheel hub meet. Let it set
over night. (optional)
3.) Use a small punch or place the edge of a regular screwdriver into one of the small
holes in the face of the free wheel.
4.) Take a hammer and strike the screwdriver driving the free wheel counterclockwise.
5.) Remove the free wheel from the wheel hub.
6.) Install the new free wheel by hand with the writing side out.
** Do not tighten the free wheel by striking with a screwdriver and hammer.
7.) Reassemble everything in reverse order.
How To Change Fuse Holder
1.) Remove the six Allen head bolts securing the deck plate.
