Page20
settles down into the groove on the throttle on the carb.
14.) Replace air filter cover and deck plate.
How To Install Fuel Lines
1.) Attach the larger diameter hose on the nipple that is straight.
2.) Attach the smaller diameter hose on the nipple that is bent at a 90 degree angle. It
also has the fuel filter attached.
3.) Squeeze the arms together on the retaining clip to increase the diameter and slide it
over the hose.
How To Install Ignition Coil
1.) Unplug spark plug from wire.
2.) Remove air breather assembly.
3.) Remove plastic covering motor and exhaust.
4.) At this point you can see the ignition coil. Remove the two bolts holding coil in
place.
5.) Reinstall new coil using a business card between the fly wheel and the coil as a
spacer. Tighten bolts with card in place, when bolts are tight then you can remove
the business card. Your coil should be gapped correctly.
6.) Reinstall the plastic motor covers and your scoot should have spark.
How To Install Engager
1.) Stick a screwdriver in the fin's on the right side of pull starter to hold the motor from
turning over.
2.) Take off net in center of engager.
3.) Unscrew and remove.
4.) Install new engager and tighten nut.
5.) Install pull starter.
How To Install Pull Starter
1.) Locate the four (4) screws on the Pull Starter.
2.) Unscrew them and the pull starter will come off.
3.) To re-install put Pull Starter on the Motor give it a little pull while holding it. This will
line it so that it sits flat on motor.
4.) Install screws and tighten.
