Page19
get down to the cable within the scooter. Pull it through the body and then through
the handle bar down tube.
3.) Unscrew the two screws on the electric start section of the throttle. This piece
should split to allow you to remove the throttle cable from the handle. Release the
throttle cable from the handle.
4.) Unscrew the metal "L" piece that goes into the electric start.
5.) Screw the new throttle's "L" joint into the old electric start.
6.) Attach the cable to the old throttle handle.
7.) Replace the top portion of the split electric start plastic piece and tighten down onto
handle bar.
8.) Thread cable through the handlebar down tube and through the scooter.
9.) Reconnect it to the throttle on the carburetor. Make sure the throttle cable end
settles down into the groove on the throttle on the carb.
10.) Replace air filter cover and deck plate.
How To Change Electric Start
1.) Unhook the throttle cable from the carburetor. Unscrew the screw from the center of
the air filter cover. Push throttle on carb to the open position and unhook cable
using a pair of needle nose pliers.
2.) Unthread the cable through the scooter. You may need to remove the deck plate to
get down to the cable within the scooter. Pull it through the body and then through
the handle bar down tube.
3.) Unscrew the two screws on the electric start section of the throttle. This piece
should split to allow you to remove the throttle cable from the handle. Release the
throttle cable from the handle.
4.) Unscrew the metal "L" piece that goes into the electric start.
5.) Remove the deck plate if it is not off already.
6.) Locate the wires that attach to the electric start and where they are attached cut
(Leaving plenty of room to splice) and label them with masking tape so that after you
have installed the new electric start you will know where they go.
7.) Cut the wire at the base of the old electric start near the handle bar. Take these
ends and tape them tightly to the ends on the new electric start. Grab hold of the old
wires inside of the scooter and pull the new wires into place. This should thread the
new wires through the down tube and into the body a lot easier.
8.) Cut and splice the new wires onto the old wires. This can be done by using small butt
connectors or wire nuts. These can be purchased inexpensively at radio shack.
9.) Screw the new throttle's "L" joint into the electric start.
10.) Attach the cable to the old throttle handle.
11.) Replace the top portion of the split electric start plastic piece and tighten down onto
handle bar.
12.) Thread cable through the handlebar down tube and through the scooter.
13.) Reconnect it to the throttle on the carburetor. Make sure the throttle cable end
