EXTERNAL COMMAND ON, THE MOTOR IS ENABLED
NO WATER, THE MOTOR IS DISABLED
WAITING FILLING, THE MOTOR IS DISABLED
14
LED KEY
Off
On
Flashing
If it should be necessary to repeat the
AUTOLEARNING
, while the motor is in automatic mode press
for at least 5 seconds the button in this way
all the data previously stored on the motherboard
will be erased.
At this point new programmation is possible.
5.3 Reset programming
6. GENERAL FUNCTIONING OF THE CONTROL PANEL
INDICATES THAT THE MOTOR IS RUNNING
INDICATES THAT THE MOTOR IS OFF
IT INDICATES A MOTOR OVERLOAD ALARM THAT CAUSES THE SHUTDOWN
SUPPLY MAINS
MANUAL OPERATION:
IT IS ACTIVATED FROM THE
STOP
STATUS BY HOLDING THE BUTTON PRESSED.
IN THIS CONDITION THE CONTROL PANEL STARTS THE MOTOR UNTIL THE BUTTON IS RELEASED EXCLUDING
THE CONTROL ON THE AUTOMATIC. RELEASING THE BUTTON YOU RETURN TO THE
STOP
STATUS
AUTOMATIC OPERATION:
IT IS ACTIVATED FROM THE
STOP
STATUS BY PRESSING THE BUTTON.
IN THIS CONDITION THE CONTROL PANEL WILL WORK ACCORDING TO DRY RUNNING PARAMETERS AND
EXTERNAL COMMAND.
STOP OPERATION:
IN THIS CONDITION THE CONTROL PANEL DOES NOT START THE MOTOR
N.B.:
THE MOTOR OVERCURRENT ALARM MUST BE RESET BY PRESSING THE BUTTON FOR 2s
N.B.: THE MOTOR STARTS ONLY IF IT IS IN AUTOMATIC OPERATION AND STOPS IF THE EXTERNAL COMMAND
IS OFF OR IN CASE OF LACK OF WATER.
ENGLISH
5. PROGRAMMING
