X-POWER 648.612, Instruction And Installation Manual

Page: 17 / 24

ENGLISH
17
5. PROGRAMMING
5.1 DIP-SWITCH setting
5.2 Trimmer adjustments
1 2 3 4
F1 F2 F3 F4
ON
OFF
DEFAULT CONFIGURATION
1 2 3
4
F1 F2
ON
OFF
APPLICATION SEWAGE
ACTIVATE TIMED PROBE
1 2 3 4
F3
ON
OFF
1 2 3 4
F3
ON
OFF
Deactivates
Deactivates
Active
Active
1 2 3 4
F1 F2
ON
OFF
1 2 3 4
F1 F2
ON
OFF
APPLICATION CLEAN WATER
Empyiting Lifting
1 2 3 4
F4
ON
OFF 1 2 3 4
F4
ON
OFF
MINIMUM AND MAXIMUM VOLTAGE PROTECTION
THREE-PHASE VERSION
1
4
10
20
7
13
16
(6)
(11)
(21)
(36)
(16)
(26)
(31)
CURRENT MOTOR 1 CURRENT MOTOR 1
(6) 1
(11) 4
10 (21)
20 (36)
(16) 7
13 (26)
16 (31)
The minimum and maximum voltage values are calibrated to a fixed value, on the single-phase version 98V and 122V while
on the three-phase 325V and 435V.
SINGLE PHASE-VERSION
2
5
11
18
8
14
16
CURRENT MOTOR 1
Through this trimmer it is possible to set the sensitivity of the conductivity between
the 3 level probes. The adjustment range is from 0 to 100 Kohm.
This trimmer is only adjusted when it is required to operate with 2 time probes
(COMMON and MINIMUM, excluding the maximum probe), to activate it just set the
SWITCH F3 on the board to ON. The adjustable time ranges from 1 to 240 minutes.
Using the CURRENT MOTOR 1 trimmer, it is possible to adjust the maximum motor overload current.
To perform a good calibration it is advisable to rotate the trimmer up to the full scale value and then,
when the motor is on, turn it counter-clockwise until the motor absorption current is detected
(the red PROTECTION Led lights up) and then increase the regulation by 20%.
10
25
50
100
35 65
80
PROBE SENSITIVITY
1
40
120
240
80 160
200
PROBE DELAY
649.615 02 649.615 03/04 648.612