Sound Active
The X-Pod
®
Router responds to notes in music and runs through
available laser patterns. Sensitivity to sound may be adjusted using the
knob on the rear of the unit. The X-Pod
®
Router responds to two sound
active modes.
Automatic Sound Active Mode: Cycles through the pre-programmed
patterns and chases built into the X-Pod
®
Router. To activate this mode
switches 1 and 10 must be UP/ON and all others must be DOWN/OFF.
Random Sound Active Mode: - Randomly turns Pod heads on and off
at intervals in the music. To activate this mode switches 1, 2 and 10
must be UP/ON and all others must be DOWN/OFF.
Auto Mode
The Router replays all available beam sequences in order and patterns
will change at four frames per second which is very near an eight note of
a 120 BPM song. The X-Pod
®
Router has two automatic modes:
Standard Automatic Mode: The Router cycles through the pre-
programmed patterns and chases built into the X-Pod
®
Router. To acti-
vate this mode switch 10 must be UP/ON and all others must be
DOWN/OFF.
Random Automatic Mode: Randomly turns Pod heads on and off at
intervals. To activate this mode switches 2 and 10 must be UP/ON and
all others must be DOWN/OFF.
DMX Mode
The Router responds only to DMX control inputs from an external DMX
controller. Sound Active and Auto modes are also accessible via DMX
Channel #1. Access DMX Mode by ensuring that pin #10 is DOWN/OFF
and use pins 1-9 to set the DMX address as show below.
DMX Channel 1
Range
Effect
Range
Effect
0-7
All Off
128-135
Cascade In and Out
Page 11
of 18
