Operation m
anual X-TRIANGL
E
www.x-dreamfly.ch
Correct disposal of the rescue equipment
As an environmentally conscious manufacturer of rescue equipment we pay great attention to produce our pro-
ducts eco social tolerated. The material we use in our products is evaluated according to environmental criteria
and sub-ject to constant control. For the proper disposal the steel fittings should be separated at the metal
disposal point. The canopy, the lines and straps can be disposed with household waste.
6. Attachment to the harness
Each new combination of harness and rescue has to be checked (compatibility check) after the first packing by the
manufacturer of the harness or by a trained and appointed person. Deploying the rescue system has to be possible
out from each flying position according with the requirements of the building regulation. It should be noted that
the release force of 7daN is not exceeded. The X-TRIANGLE must be connected with a carabiner or by looping
through the V-line to the harness. When using a connection carabiner the breaking load of the carabiner must
have a min. of 2400 daN. If the X-TRIANGLE is connected to the shoulder area with two carabiners or as a front
container on two lateral attachment points (usually the front container is mounted on the main carabiners), each
individual carabiner need to have a strength of 1200 daN at least.
7. Packing interval for the X-TRIANGLE
Before the rescue is repacked it must be subjected to a visual inspection by the packer. The reserve parachute
must therefore be aired at a humidity of 60 - 65 % for min. 24 hours. The packing shall be done as possible on a
packing table, but at least on a clean, anti static surface. The following photos are from a X-TRIANGLE.
We remind you that you fly at your own risk.
This also applies to the use of this life-saving device.
page 13 of 39
