Revision J 9/30/2014 R830000-1060
Quick Start Guide, XDSPRO Receiver
Page 11 of 11
Important Notice
Users Manual
The XDS-PRO4 DVB Satellite Receiver Users Manual is available on-line. To access the Manual, please log-on to
http://myxdsreceiver.cmneng.com
with your Affiliate’s web page access information, go to Help, and select: Users
Manual. If you have any questions, please contact your Affiliate Station, or the Help Desk.
FCC Compliance
T
HIS DEVICE COMPLIES WITH
P
ART
15
OF THE
FCC
RULES
.
O
PERATION OF THIS DEVICE IS SUBJECT TO THE FOLLOWING TWO CONDITIONS
:
(1)
T
HIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE
;
AND
(2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED
,
INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION
.
UL and CSA Compliance
T
HE
XDS-PRO4
DVB
S
ATELLITE
R
ECEIVER WAS TESTED ACCORDING TO
UL
60950-1:2003
AND
CSA
C22.2
N
O
.
60950-1:2003.
T
HIS DEVICE MEETS THE SAFETY AND TEST REQUIREMENTS OF THE TEST SPECIFICATIONS
,
AND WAS FOUND TO BE IN COMPLIANCE WITH
PROTECTION AIMS OF THE APPLICABLE
EC-
DIRECTIVES AND THE REQUIREMENTS OF THE STANDARDS
.
THE
XDS-PRO4
DVB
S
ATELLITE
R
ECEIVER MAY BE MARKED WITH THE
TUV
MARK AS SHOWN BELOW
;
C
ERTIFICATE
N
O
.
U8
07
01
62269
001
Acknowledge of Trademarks
Any product or corporate names used herein may be trademarks or registered trademarks, and are only used for
identification and explanation, without intent to infringe. Any terms mentioned or used that are known trademarks
or service marks have been appropriately capitalized and italicized. X-Digital Systems, Inc. cannot attest to the
accuracy of this information. Use of a term in this document should not be regarded as affecting the validity of any
trademark or service mark.
Patent Pending
X-Digital Systems, Inc., DVB Satellite Receiver – Patents Pending
Disclaimer
This document is intended to provide information about the “XDS-PRO4 DVB Satellite Receiver”. Every effort has
been made to make this document as complete and accurate as possible, but no warranty or fitness is implied. The
information is provided on an “as is” basis and X-Digital Systems shall have neither liability nor responsibility to any
person or entity with respect to any loss or damages arising from the information contained in this document.
Warning!
Approved external telecom power cross protection must be incorporated into the final installation in accordance with
Annex NAC of UL/CSA standard 60950-1. Failure to comply may result in a fire or electric shock hazard and will void
regulatory compliance certification.
Warning!
Approved external telecom power
cross
protection
must
be
incorporated
into
the
final
installation in accordance with
Annex NAC of UL/CSA standard
60950-1. Failure to comply may
result in a fire or electric shock
hazard and will void regulatory
compliance certification.
