1226 R830002-1060
XDS Pro Users Guide
1/11/2010
Rev A
8.2
Console Commands
Tasks are performed through the console via commands. The syntax for any command is
the name of the command, followed by a comma separated list of one or more option
command arguments. Below is a list of all commands available along what command
arguments are required and what the command does.
The ALARM Command:
The ALARM command tells you, and allows you to change,
the current ALARM mask the receiver is using. To see the current ALARM mask
without modifying it, simple type ALARM without an argument following it. To change
the alarm mask, type: ALARM <MASK>, where <MASK> is a hexadecimal digit in the
range [0-FFFFFFFF]. Anything larger than FFFFFFFF will be interpreted as the largest
mask, FFFFFFFF. This command is only available to the tech profile.
The E0 and E1 Commands:
The E0 and E1 commands change various settings for the
first and second Ethernet ports respectively. The command followed by any of the below
options will display that parameter if there is no argument given, or change that
parameter to the argument if an argument is given.
Option
Argument
Action
SHOW
Shows various technical data regarding the specified
port.
MAC
Same as the SHOW option.
DHCP
[ON/OFF]
Sets DHCP to ON or OFF depending on the argument.
ADDR
[a.b.c.d]
Sets the Ethernet port‟s address to argument.
MASK
[a.b.c.d]
Sets the Ethernet port‟s subnet mask to the argument.
PROXY
[a.b.c.d]:PORT
Sets the Ethernet port‟s proxy address and port.
DNS
[a.b.c.d],…
Sets the Ethernet port‟s DNS servers. One to three DNS
addresses can be specified in a coma delimited list.
GATEWAY
[a.b.c.d]
Sets the Ethernet port‟s gateway to the argument.
WWW
[a.b.c.d],[w,x,y,z]
Sets the Ethernet‟s primary URL to the first argument,
and sets the secondary URL to the second argument.
Table 2. E0 or E1 Command Parameters
These commands are available to the tech and user profile.
The FACTORY Command:
This command will reset all of the receiver‟s settings to
factory defaults. The syntax is FACTORY DEFAULTS, [USER/FULL] where USER
will reset basic settings to factory defaults and FULL will additionally reset Ethernet and
Tuner parameters. Using this command will require a receiver restart.
This command is only available to the tech profile.
