- 6 -
Input Characters/Numbers
When you operate this system, there are cases when a number or a name is required to be
entered by you. Such cases could be entering the Counter quantity or a Hard Drive
Partition/Image name.
To enter an alpha numeric character, you need to use the
Up
or
Down button
to scroll
through varies numbers or letters then use the
ENT/Enter
or
ESC/Escape
button to move the
cursor position right or left. O
nce you’ve finished, move the cursor to OK and press the
ENT/Escape
button.
The below example is meant to illustrate how to enter a partition/image name. For
detail procedures on how to create a new partition/image or rename an existing
partition/image, please refer to;
Section 1: Loading Master Disc content into the Hard
Drive as a partition/image on page 12
.
For example, if you want to enter a part
ition name of “FUN1”, do the following
:
a) Press the
Down button
repeatedly until “F” is displayed.
b) Press the
ENT/Enter
button once to move the cursor to the next position.
c) Press the
Down button
repeatedly until “U” is displayed.
d) Press the
ENT/Enter
button once to move the cursor to the next position.
e) Press the
Down button
repeatedly until “N” is displayed.
f) Press the
ENT/Enter
button once to move the cursor to the next position.
g) Press the
Down button
repeatedly until “1” is displayed.
h) Press the
ENT/Enter
button repeatedly to move the cursor to OK. Then, press the
ENT/Enter
button once to submit your selection and proceed to next step.
When you enter a number, normally it asks for a 4 digit number. If your number is
less than 4 digits, you need to fill the leading spaces with 0s (any leading zeros will
be skipped). An example of that would be 0234 (Two hundred and thirty four) or
0010(ten).
Edit Partition Name:
[ ],OK?
