Front Panel (TX/RX)
Rear Panel (TX/RX)
RS-232 Mode
Switches the mode for the RS-232 port.
Normal:
RS-232 HDBaseT pass-through
Update:
RS-232 firmware update
Power LED
Solid:
The transmitter is powered On
Off:
The transmitter is powered Off
Status LED
Flashing:
The transmitter is operating
normally.
Off:
The transmitter is Not operating
normally.
LINK LED
Solid:
Link to receiver has been
established.
Flashing:
Link to receiver has not been
established.
HDCP LED
Solid:
Audio and Video signal is HDCP
protected.
Flashing:
Audio and Video signal is not
HDCP protected.
Off:
No Audio and Video signal.
Power In
5.5mm Male Barrel Jack
Connect to the included 18V DC 1A power
supply. Only connect to the transmitter
when using PoH.
See
.
HDBT Out (TX)
HDBT In (RX)
8-pin RJ-45 female Connect the
transmitter
HDBT Out
to receiver
HDBT In
.
See
IR TX/RX
3.5mm (1/8in) Mono Plug
IR TX
: Connect to the supplied IR emitter
to control a local device from the remote
display location via HDBaseT.
IR RX
: Connect to the supplied IR receiver
to send IR to the remote display via
HDBaseT.
See
.
RS-232
3-pin Screw Down Phoenix Connector
Used to send and receive RS-232 signals
to/from the source location via HDBaseT
and firmware updates. See
.
HDMI In (TX)
HDMI Out (RX)
19-pin type A HDMI female digital video/
audio: Supports HDMI and DVI/D (requires
adapter-not included). Limited to 297MHz
pixel clock
Copyright © 2015 WyreStorm Technologies |
EX-35-4K Quickstart Guide | 160127
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
