WYLER BlueLEVEL-2D, Manual, Page: 20 / 65

page 20 of 65 pages
3.2 S
ELECTION OF THE MEASURING UNIT
/ UNIT
3.2.1 S
TANDARD
-
UNITS
You can change the measuring unit of the inclination values displayed. If yo u start the function [UNIT]
the list of the available measuring units will appear. With the keys you can now
select the measuring unit preferred. For memorizing the measuring unit selected you press now the
key . The measuring unit will remain active until you change it again according to the
above procedure.
The following
measuring units can be chosen.
xxxx.xx mm/m mm per m / 2 decimals
xxx.xxx mm/m mm per m / 3 decimals *
xx.xxxx "/10" inch per 10 inches / 4 decimals
xx.xxxx "/12" inch per 12 inches / 4 decimals
xxxx.xx mRad Milliradian / 2 decimals
xxx.xxx mRad Milliradian / 3 decimals
xxxx.xx mm/REL mm in relation to the relative base / 2 decimals
xxx.xxx mm/REL mm in relation to the relative base / 3 decimals *
xx.xxxx "/REL inches in relation to the relative base / 4 decimals
xxxx.xx A %
o
artillerie-permille
xxxx.xx %
o
permille
xxx.xxx° DEG degrees / 3 decimals
xxx° xx' DEG
degrees / minutes
xx° xx' xx" DEG degrees / minutes / seconds
xxxx' xx" DEG minutes / seconds
xxxxxx" DEG seconds
xxxxx.x" DEG seconds *
xxx.xxx GON gon / 3 decimals
xx.xxxx GON gon / 4 decimals
Depending on the unit selected the last digit will be rounded to 5" or to the nearest lower integer
(e.g.20 µmm/m).
3.2.2 U
NITS WITH RELATIVE BASE LENGTH
The units mm/REL and "/REL are related to a relative, this means selectable, base length. After
selecting one of these units, the relative base length must be entered.
Example:
mm/REL / mm in relation to a relative base / 2 decimals.
After the selection of the measuring unit in our example the
stored base length of 1000 mm will appear.
With the keys the proposed base length
can be modified. The newly entered value can finally be
confirmed with the key.
With the key the default value 1000 mm will be
recalled.
The following measurements are now related to a base length
of 1250 mm.