Power Unit Assembly
Page 10
February 2016
SCR-UM-00364-EN-02
Throttle Cable Adjustment
The throttle cable comes pre-assembled for your convenience� Over time you may notice
that it takes more clicks on the throttle to reach the optimum RPM level than when you first
ran the screed� This is normal as the throttle cable stretches over time�
Figure 13: Throttle cable adjustment
To adjust your throttle cable to compensate for this stretching:
1� Locate the barrel adjuster where the cable runs into the underside of the engine�
2� Turn the barrel adjuster counterclockwise with an 8 mm wrench�
3� Tighten the locknut to hold it in the desired position�
Attaching the Screed Bar
1� Locate the threaded studs on the screed bar and loosen the locking handles�
2� Slide the power head of the screed over the threaded studs�
3� Fasten the power head to the bar using the locking handles and washers provided,
as shown below� The washer and lock-washer should contact the silver handles when
installing the power unit�
Figure 14: Attaching the screed bar
4� Make sure to fully tighten the bolts so they do not come loose during use�
