Oil Level Check
Page 5
February 2016
SCR-UM-00364-EN-02
The Screed King power screed is designed and manufactured to meet the needs of a
discriminating buyer for the efficient finishing of concrete�
The directions left, right, front and rear as mentioned throughout this manual, are as seen
from behind the machine, standing between the handles�
OIL LEVEL CHECK
OIL FILLER CAP/DIPSTICK
LOWER LIMIT
OIL FILL HOLE
(bottom edge)
Figure 1: Oil filler hole location
It is important that the engine oil level be maintained at the correct level� High or low oil
levels cause permanent damage to the engine requiring replacement� To check the oil level:
1� Place the screed board on a flat level surface to perform an oil level check�
2� Carefully unscrew the oil filler cap/dipstick and wipe it clean�
3� Insert and remove the oil filler cap/dipstick without screwing it into the oil reservoir
neck, to check the oil level shown on the dipstick�
4� If the oil level is near or below the lower limit mark on the dipstick, fill the reservoir to
the bottom edge of the oil fill hole with the recommended oil� See the Honda engine
owners manual for more information�
5� To avoid overfilling or underfilling, make sure the engine is in a level position when
adding oil�
6� Reinstall the oil filler cap/dipstick and tighten securely�
MPORTANT
I
Running the engine with a low oil level can cause engine damage. This type of damage is not
covered by the warranty.
