6 Keep cutting tools sharp and clean
7 Use the power tool, accessories, tool bits, and like
equipment in accordance with these instructions, taking
into account the working conditions and the work
to be performed
Service
Have your power tool serviced by a qualified repair person
using only identical replacement parts to make sure the tool
is safe to use
Emissions
1 Declared noise emission values:
K = 0 69 dB
L
pA
= 83 1 dB
L
WA
= 94 1 dB
OTEE:
N
Wear hearing protection
2 Declared vibrator emissions:
Front Handle = 4 28 m/s
2
K = 1 50 m/s
2
Rear Handle = 2 41 m/s
2
K = 1 50 m/s
2
OTEE:
N
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one tool
with another The declared vibration total value may
also be used in a primary assessment of exposure
WARNING
THE VIBRATION EMISSION DURING ACTUAL USE OF THE
POWER TOOL CAN DIFFER FROM THE DECLARED TOTAL
VALUE DEPENDING ON THE WAYS IN WHICH THE TOOL IS
USED.
SAFETY SYMBOL EXPLANATIONS
Volts
Amperes
Hertz
Alternating Current
Class II Tool
IP Symbol
Ground Terminal (Protective Earthing)
ON
OFF
Refer to Instruction Manual
Variability in Steps
V
A
Hz
IPX4
Figure 1: Safety symbols
Additional Safety Note
Double insulated tools are equipped with a polarized plug
(one blade is wider than the other) This plug will fit in a
polarized outlet only one way If the plug does not fit fully
in the outlet, reverse the plug If it still does not fit, contact
a qualified electrician to install a polarized outlet Do not
change the plug in any way Double insulation eliminates
the need for the three-wire grounded power cord and
grounded power supply system
Safety Symbol Explanations
Page 6
February 2020
VBR-UM-02653-EN-05
