OTEE:
N
If the casing feels loose or too tight after pushing
down on the locking lever, raise the lever until the
lever is horizontal then rotate the hex head screw
with a #4 Allen wrench in either direction to tighten
or loosen Be careful to not loosen the lever too
far or the lever bushing and screw will unthread
and could fall apart After the adjustments are
completed, push lever back down to bottom out to
connector This procedure may need to be repeated
to get desired tight or lose condition See
Locking
Lever
Figure 6: Locking lever adjustment
Disconnecting the Vibrator Casing
(Quick-Disconnect)
1 Make sure the quick-disconnect locking lever on the
motor is in the up position
2 Rotate the core and casing counterclockwise from the
lock position to the unlock position
3 Pull the casing end straight out of the quick-disconnect
connector on the motor
4 Make sure that the locking lever is in the down position
when storing the motor to avoid damage to the lever
Connecting the Vibrating Casing
(Threaded Connections)
OTEE:
N
The casing must be fitted with a thread
connector end
Figure 7: Threaded casing connector
1 Line up threads of the shaft with the threaded motor
connector Hold the casing end firmly and rotate the
casing until it engages into the motor
Shaft
Threads
Figure 8: Shaft insertion
Setup
Page 9
February 2020
VBR-UM-02653-EN-05
