UV Purification Systems
7
Setting Up
Installation
Carefully select the location for the UV system and any related components. Note
the direction of water flow in the supply line to which the unit is being connected.
Refer to the appropriate exploded view diagram for your unit and check to see that
you have all the necessary fittings.
Parts List: 4 screws 1 quartz dome or sleeve, 1 or 2 O-rings
1 alcohol wipe 1 Allen key wrench
1 UV lamp w/ O-rings on each end
Turn off the main water supply valve. Fasten unit to wall, using the mounting clips
(”pipe hangers”) and screws provided. Press the UV chamber into the clips for a
secure hold.
Install new plumbing, making sure the In and Out ports on the filter set point in
the direction of water flow. Installation of bypass and valves is recommended.
Install filter set
Install UV unit
Complete installation with pre-filter set and UV.
Inlet/Outlet shutoff valves are recommended.
After installation of the plumbing is
complete, install electrical components
(surge suppressor and ballast, monitor if
present) ABOVE the water line.