Wybron FORERUNNER 4540, User Manual

Page: 12 / 22

12
2. Attach the color changer to the fixture
Slide the color changer's mounting bracket into the gel frame holder of your fixture and
lock the gel frame retention clip (if available).
If the mounting plate installed on your color changer doesn't fit the fixture, you may
replace it with a differently sized plate. See page 15 for information on changing
mounting plates.
The mounting plate allows you to position the color changer with the gelstring rolling
either horizontally or vertically. However, Forerunner operates most effectively with the
fan blowing air vertically (as hot air naturally rises).
3. Attach the safety cable
A safety cable is attached to the back, right hand side of the color changer. Run this
cable around the pipe or truss from which you hang the light fixture and clip it to itself
(fig. 5).
4. Attach the power supply to the truss
The Power Supply is designed to attach directly to the pipe or truss of your lighting rig.
The power supply comes with a mounting
bracket which hooks over the pipe or truss
and is then locked into place with a thumb
screw.
Once you have the power supply positioned
and locked into place, connect the safety
cable by running it around the pipe or truss
to which the power supply is attached.
Note: For cabling purposes, it may be
preferable to position your power supply
toward the center of the pipe or truss and
daisy chain either direction from it.
Figure 5