WWBeds Face Unassembled Alpha Murphy, Assembly Instructions Manual, Page: 16 / 18

Caution:
Hold the Face Panel securely, Do Not let it slam shut. Balance is not achieved until the mattress is loaded in
the bed and will not stay down.
Holding the upper edge of the Bed Panel Unit, gently let the bed closed. If all is well, you should have even
clearance between the side edges of the panel unit and the insides of the Side Panels.
If the Cabinet is not square and the Bed Panel Unit binds try the following adjustments.
● Nudge the Bed Cabinet along the floor, pushing from the base of the Side Panel
● Shim (or reshiim the bottom of the Side Panels for floors that may be out of square.
Plug in the Lights:
Mount the small control box to the back of the “Frame and face Panel”. Remove the tape backing and stick the control
box to the back of the metal frame.
​ Make sure the arrow is facing up and toward the wall ​ .
Complete Bed Assembly
Follow up to Initial Assembly
Video:
​
Finishing Up
Check that the Bed Cabinet is level and square
so the Bed Face has equal clearance of the
Cabinet on both sides, top to bottom. If the
Cabinet is leaning to one side, nudge it at the
floor level. If the top is uneven, place shims
under the Side Panels. If bed is too heavy to
operate easily or slams shut, remove the Bed
Face Panel and add or subtract springs. At this
time, you may decide to use one more or less
spring(s) on the left or right side Lift Mechanism.
7-1 Add Cover Plates
You should have a left and right cover plate and
two 1-½” wood screws. The cover plates have
tabs on them. Slide those tabs into the slot in the
top if the mechanism.
Slip the Mechanism Cover over the Mechanism so that the tabs on the cover fit into the notches. Line up the
hole with the barrel support and anchor in place using the 1-½” screw provided Repeat on the other
Mechanism.
7-2 Strap the mattress into place.
7-3 Add any accessories like crown or bookcases.