WWBeds Face Unassembled Alpha Murphy, Assembly Instructions Manual, Page: 14 / 18

Frame Bolts and Straps
Three holes used in the frame starting at the head
end.
Hole 1. Starting with Hole #1 inset the Alen Head
bolt and secure it with a Nylock Nut on the inside.
Use the Allen wrench provided and a ½” wrench or
socket to tighten.
Hole #2. For now skip hole #2. This will be used to secure the bed to the spring are in a later step;
Hole #3. From the outside inset a 5/16” Hex Head Bolt. Get. Only thread the Nylock nut but don’t tighten yet.
Repete the for the other side.
Mattress Straps
Some customers will skip this step as the leg, when folded around, does a great job of securing the mattress.
Remove the screw that is in the bed right above the Stiffener, closest to the foot of the bed. Add a washer to
the screw and screw down the doubled up end of the strap. Repete for the other side making sure the strap is
not twisted. (see
​ video ​ )
Mounting the Legs
Video:
​
Legs
You’ll need Hardware Pack 4, ½” wrench or socket, 7/16” wrench.
L-1 Note the order of washers. This is very important. Start with a
Nylon Washer and put it on the leg.
(NOTE: A second Nylon Washer on the inside is not shown in the
diagram.
L-2 Put the leg through the hole toward the foot of the bed.
L-3 From the inside add a second Nylon Washer (not shown in
picture), Still Filler Washer, Steel Holding Washer, and then the
Nylock Nut.
L-4 With a ½” wrench or socket tighten the Nylock nut but not too tight. You will want the leg to move freely.
Repete for the other side.