12–English
8.2.10
Recommendations for Optimal
Handling of the Battery
Protect the battery against moisture and water.
Store the battery only within a temperature range
between 0 °C and 45 °C. As an example, do not
leave the battery in the car in summer.
A significantly reduced working period after charg-
ing indicates that the battery is used and must be
replaced.
Observe the notes for disposal.
Maintenance and Cleaning
❏
Before any work on the machine itself
(e. g. maintenance, tool change, etc.) as
well as during transport and storage,
remove the battery from the power tool.
There is danger of injury when unintentionally
actuating the On/Off switch.
❏
For safe and proper working, always keep
the machine and ventilation slots clean.
Replacing the blade (see figure A)
The upper cutter
9
and the bottom cutter
10
are
identical, have four cutting edges each, and can be
exchanged with each other.
Turn or replace the cutters in good time. Only sharp
application tools achieve good cutting capacity and
make the machine last longer.
To replace the upper cutter
9
, loosen the fastening
screw
8
; to replace the bottom cutter
10
, loosen the
fastening screw
12
.
Turn the cutter by 90° or install a new cutter. When
installing the bottom cutter
10
, pay attention that it
faces against the adjustment screw
11
.
☞
Note:
Turn the cutter only in the direction
indicated in the figure and insert a new cutter
only in the position shown in the figure. Cut-
ting is not possible with an incorrectly inserted
cutter.
Retighten the fastening screw
8
for the upper cutter
and the fastening screw
12
for the bottom cutter with
a tightening torque of 3–4 Nm. Check the cutter
clearance
a
(see “Adjusting Cutter Clearance a”,
page 11).
Upper cutter
9
and bottom cutter
10
may not be
reground.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair
should be carried out by a Würth master-Service.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
The current spare parts list for this power tool can be
viewed in the Internet under
“http://www.wuerth.com/partsmanager”
or be requested from your next Würth branch office.
Guarantee
For this Würth power tool, we provide a guarantee
in accordance with the legal/country-specific regula-
tions from the date of purchase (verified by invoice
or delivery document). Damage that has occurred
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent
undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth power tools.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into house-
hold waste!
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implementa-
tion into national right, power tools that are no
longer usable must be collected separately and dis-
posed of in an environmentally correct manner.
Do not dispose of battery packs/batteries into
household waste, fire or water. Battery packs/batter-
ies should, if possible, be discharged, collected,
recycled or disposed of in an environmental-friendly
manner.
Only for EC countries:
Defective or dead out battery packs/batteries must
be recycled according the guideline 2006/66/EC.
Subject to change without notice.
OBJ_BUCH-1120-001.book Page 12 Monday, February 8, 2010 10:07 AM
