WIRELESS CONNECTIVITY & SENSORS
User manual Setebos-I
4 Quick start
The Setebos-I module comes pre-flashed, tested and ready to use out-of-the-box. This chapter
describes the steps to quickly build a prototype system and test the capabilities of the module.
Depending on the radio protocol in use (Bluetooth Low Energy 5.1 or Proprietary), specific
quick start information and examples can be found on the Proteus-III [1] and Thyone-I [2] user
manuals.
4.1 Minimal pin connections
UTXD
URXD
RTS/CTS
/RESET
ANT
RF
Host
Controller
Setebos-I
VDD
1
6
3
5
WAKE_UP/BOOT/MODE_1
BUSY/LED_1/LED_2
7
8
4
SW
D
IO
/S
W
D
C
LK
9
VDD
RPS
2
GND
GND
1
Figure 4: Minimal pin connections
The above image shows the steps to be performed to integrate the Setebos-I into a custom
end device.
1. Supply voltage and ground
Connect the
and
pins to supply the radio module with power.
2. Radio standard selection
Connect the
to the host controller to choose between the radio standards.
3. UART serial interface to the host
Connect the UART pins
and
to the host to control the module via host.
Order code 2611011024020
17
Version 1.1 , July 2022
