Würth KNS 150-E, Translation Of The Original Operating Instructions

Page: 18 / 172

18
Troubleshooting
The electronic signal display [6] lights up
and the load speed decreases.
The coil temperature is too high! Run the machine in
idling until the electronic signal display goes out.
The electronic signal display [6] flashes
and the machine does not start.
The restart protection is active. If the mains plug
is inserted with the machine switched on, or if the
power supply is restored after an interruption, the
machine does not start up. Switch the machine off
and on again.
High-energy, high-frequency interference
High-energy, high-frequency interference may result
in the machine switching off. If this happens, switch
off the machine, disconnect and reinsert the mains
plug. As soon as the interference is reduced, work
can be resumed.
Environmental protection
Do not dispose of the device with
domestic waste. Dispose of the
device only via an authorized waste
management company or your
municipal waste management
organisation. Adhere also to the
applicable regulations. In case of
doubt refer to your waste management organisation.
Recycle all packaging material in an environmentally
friendly manner.
Warranty
This Würth device is covered by warranty according
to the applicable national regulations. The warranty
period begins on the date of purchase (please retain
invoice or delivery note as proof of purchase).
Faults covered by warranty shall be eliminated by
replacement or repair. Damage caused by improper
operation is not covered by warranty.
Claims can be recognized only if the device is in a
non-disassembled state and presented to a Würth
branch office, your Würth sales representative or a
customer service office authorized by Würth.
Technical changes reserved.
We accept no liability for printing errors.
Spare parts
In the unlikely event of a failure or defect, have the
device examined and repaired by a
Würth masterService® workshop.
In all your queries and spare part orders, always
quote the product number (see type plate) of your
device.
The current spare parts list of the device can be
viewed online at http://www.wuerth.com/partsman-
ager. Alternatively, contact your local Würth agency
for a hardcopy.
Declaration of Conformity
We herewith declare that this product conforms with
the following standards and directives:
Standards
• EN 60745-1:2009 + A11:2010
• EN 60745-2-3:2011 + A2:2013 +
A11:2014 + A12:2014
• EN 55014-1:2006 + A1:2009 + A2:2011
• EN 55014-2:1997 + A1:2001 + A2:2008
• EN 61000-3-2:2006 + A1:2009 + A2:2009
• EN 61000-3-3:2008
• EN 50581:2012
in line with the regulations of the directives:
EC directive
• 2006/42/EG
• 2014/30/EU
• 2011/65/EU
Technical documentation with:
Adolf Würth GmbH & Co. KG, Abt. PPT
Reinhold-Würth-Straße 12 – 17,
74653 Künzelsau, GERMANY
F. Wolpert Dr.-Ing. S. Beichter
Authorized Signatory,
Head of Product Man-
agement
Head of Quality,
Authorized Signatory
Künzelsau: 16.06.2016