Würth 0891 385 008, Translation Of The Original Operating Instructions

Page: 16 / 164

16
After use
Note
Observe the notes in the “safet section.
Never allo li uid to get into the device.
▸
Pull the red knob of the piston manometer [8] up
until the container is depressurised.
(Fig. )
▸
Lock the plunger ith handle [10] . (Fig. )
▸
Screw the pump
[2]
out of the container.
(Fig. )
▸
Dilute the residual uantit t ice se uentiall ,
each time ith 1/2 litre of ater, and spra this
li uid onto the treated surface.
▸
Wipe o the device using a damp cloth.
▸
To dr and store, store the container [1] and
pump
[2]
separatel in a dr , frost-free environ -
ment, shielded from sunlight.
(Fig. 12)
▸
fter use, clean the protective e uip -
ment.
Faults
Fault Cause Remed
The device does not build up
an pressure.
Pump not scre ed in tightl .
Scre the pump in tightl .
O-ring
[13]
on the pump defec -
tive. (Fig. 1 )
Replace O-ring.
Sleeve [14] defective. (Fig. 1 ) Replace sleeve.
Li uid escapes out of the
pump.
Valve disc [15] dirt or defec -
tive.
(Fig. 1 )
Clean or replace valve disc.
Piston manometer indicates
no container pressure, safet
valve blo s o too earl .
Piston manometer
[16]
defec -
tive. (Fig. 1 )
Replace the piston manometer.
Nozzle does not spra , even
though pressure is available.
Filter
[1 ] (Fig. 1 )
and/or noz -
zle [17] (Fig. 1 ) clogged.
Clean filter or/and nozzle.
Shut-o valve does not close. O-Rings [23] of the pressure
pin
[24]
not greased/lubricat -
ed. (Fig. 21) .
Grease the O-ring of the pres -
sure-pin (disassemble and/or
assemble shut-o valve)
Li uid escapes ithout activa -
tion of the lever.
Piston pin
[24]
or O-rings
[23]
defective. (Fig. 21) .
Replace pressure pin or O-ring.
Spraying pressure
pra rate ith at
jet nozzle (initial
e uipment)
1.5 bar
0.56 l/min
2.0 bar 0.65 l/min
3.0 bar 0.80 l/min
▸
If the pressure in the spra appliance falls b
0.5 bar or more belo the optimum value, pump
the pressure up again.
Note
If air containing li uid comes out of the
nozzle, the container is empt .