Installation manual
• Revision: 00 • 30/04/2021
© ABM Fahrzeugtechnik GmbH
Page 8 of 8
Make sure that all operating elements present on the handlebar are adequately positioned,
even in maximum steering angle. The brake and clutch cylinders must be in an adequate
operating position.
Pay attention to the freedom of movement of the handlebar, its mounted parts and adequate
steering angle to each side. The handlebar must be able to be moved easily from side to side.
Check the free play of the throttle cable: In maximum steering angle to both sides and with the
engine running, the motor speed must not change.
After completing the work, check the firm fit, function and tightness of all components and
screws. Make sure that there is sufficient brake fluid in the reservoir. Also check the front
wheel's freewheel and the functionality of the brake system. Further, the function of the clutch,
the throttle grip, the electric system and the anti-theft devices must be checked.
Afterwards, a test drive must be carried out! After completion of the test drive, all screw
connections must be re-checked for firm fit, tightness and all movable parts for adequate free
travel. Re-test the front wheel's freewheel and check the brake system for overheating. Check
the brake fluid level in the reservoir for significant changes.
Fasten all screws with thread-locking fluid (medium
strength) and the preset tightening torque.
Check the proper function of the electrical system.
4
Final check
