wtw inoLab Cond 730, Operating Manual

Page: 21 / 80

Cond 730 Operation
21
4.2.1 Conductivity / Specific resistance
Note
You can display measured values in the units
µ
S/cm (con-
ductivity) or M
Ω
·cm (specific resistance). This setting is de-
scribed in Abschnitt 4.7 C
ONFIGURATION
.
Thus, you can carry out conductivity measurements or mea-
surements of the specific resistance:
Conductivity
Specific resistance
1 Perform the preparatory activities according to
section 4.2.
2 Immerse the conductivity measuring cell into the test
sample.
3 Press the
m
key until appears in the status
display. Depending on the setting, one of the
following display indicators appears on the display:
4 If necessary, set the temperature by pressing
82
(see section 4.2 on page 19).
5 Wait for a stable measured value.