wtw DIQ/S 182-MOD, System Operating Manual

Page: 82 / 150

The SETTINGS menu System 182
5 - 4 ba75504e07 04/2012
5.4 Relay output R1/R2/R3
In these menus you can link sensors with the relay outputs of the
Universal Transmitter and adjust the outputs. The various setting
options are described in detail in the chapter 6 R
ELAY OUTPUTS
menu.
5.5 Modbus configuration
You can set the following Modbus interface parameters in this menu
(proceeding, see section 7.3).

Instrument address

Baud rate

Parity
All information needed to connect the DIQ/S 182-MOD to a Modbus
plant is given in chapter 7 M
ODBUS CONNECTION
.
5.6 System
The settings in the SYSTEM menu comprise:

Date/Time

Pressure/Altitude
This setting is important if you want to carry out D. O. measurements
with the System 182.
(adjustable range: 500 ... 1100 mbar or 0 ... 5955 m altitude).

Settings
a
/
z?
Here you can configure the password for the settings.
For details on the passwords refer to section 4.6.

Calibrate
a
/
z?
Here you can configure the password for calibration.
For details on the passwords refer to section 4.6.

Display contrast
Here you can set the display contrast for optimum readability.

Delivery state
Here you can reset all settings to default. Only the date, time and
contrast setting for the display will remain stored. If the settings
password is active, a password prompt appears before the reset. In
any case a security prompt appears to prevent an inadvertent reset.