Wren V5BT14, Setup Manual

Page: 18 / 64

18
Using TrueWireless Stereo
Once you have established a TrueWireless
Stereo connection between your right and left speakers, you are ready to enjoy big,
bold stereo sound. Here’s how it works:
To play music, simply select the
right speaker from your device’s
speaker selector and begin
streaming music from any source
on your device. You will notice that
the left speaker does not appear
in your source device’s speaker
selector: that’s because it is already
paired with the right speaker and
will accept a
Bluetooth signal from
the right speaker only.
You can balance the output of
each speaker relative to your
listening position by using each
speaker’s volume control. This is
especially useful if your listening
area is closer to one speaker than
to the other. If you are about the
same distance from each speaker,
you will probably want to turn
each to maximum volume and
use your source device to adjust
the overall volume of the system.
(See “Important Note on Volume
Control” on page 12.)
Your speakers will remain in
TrueWireless Stereo mode until they
are disengaged. Even when they
enter “sleep” (power saving) mode,
they will remain in TrueWireless
Stereo mode and will operate in that
mode when they wake up.
To disengage the TrueWireless Stereo
mode and use your Wren V5BTs as
individual speakers, press and hold
the Power button for 7 seconds until
the speaker turns off. When you turn
on the speaker it will no longer be in
TrueWireless Stereo mode. Be sure
to do this to both speakers when
you want to disengage from
TrueWireless mode.
If you unplug your speakers to
move them to another location or
lose power for any other reason,
TrueWireless Stereo mode will be
disengaged and the speakers will
default to the original individual
speaker mode.