WHIRLPOOL KEY
KEY1
KEY2
KEY1: Disinfection On/Off
KEY1: Whirlpool On/Off
KEY2: Venturi On/Off
DISINFECTION ON/OFF KEY
VENTURI ON/OFF KEY
To turn on the hydromassage function, fill the bath up to 5 cm., over the
hydromassage slit (if the level goes below this slit, the function deactivates
in 3 seconds).
Press
KEY 1
to switch on the pump generating the supply in the bath with
pressurised water: the function is confirmed with the indicator light on, on
the key.
If you want to stop the function, simply press
KEY 1
again and the
simultaneous switching off of the indicator light confirms it is off.
The function however has an automatic safety stop after 15 minutes.
The function activates in the presence of a sufficient water level in the bath
through prolonged pressure on
KEY 1
( approx. 5 seconds ) to request
activation of the function, the indicator light starts to flash, to confirm the
disinfection cycle press
KEY 1
again during the third flash of the indicator
light. The active function is signalled by fast flashing of the indicator light.
The function automatically stops after 5 minutes.
This function can only be switched on if the Whirlpool is already on.
To switch on, press
KEY 2
. The indicator light switches on to confirm
activation. The bath starts to fill with water mixed with air, with a whirling
effect. To stop it, simply press
KEY 2
again and the simultaneous switching
off of the indicator light confirms it is switched off.
If you want to stop the function, simply press
KEY 1
again and the
simultaneous switching off of the indicator light confirms it is off.
Page 15
USING PHANTOM WHIRLPOOL 1700 COMMAND PANEL
