Wren Turbines Ltd. MW54 Mk2 & Mk3 Turbo-Jet, kit assembly instructions, Jun 2004
Page 21
Set-up for bench-test running
With Fadec ECO ECU and switch starter.
Set up is the same as for manual ECO except that the
green cover
*
and starter pod
*
are fitted to the engine.
Connect a “switch-start”
*
lead to the starter and a 6-
cell nicad
*
to the lead. The starter is then controlled by
the switch. Note the switch must short the motor on
release of the switch to snap the starter clutch out of
engagement.
The same setup can also be used for the FOD screen
*
starter mounting. This setup is usually utilised for
helicopter and turbo-prop installations.
Note, picture shows Mk2 version, Mk3 version uses
same setup and accessories.
NB
.
*
Indicates accessories available from Wren Turbines Ltd
.
“ECO” ECU
Temperature
probe
Switch starter
lead
R/C Receiver
Fuel pump
Gas can and valve
To ECU Pump supply
ECU display
Fuel in from
tank
Summary of Contents for MW54 Mk2
Page 1: ......
