Page
26
of
39
WIM-TD-002_C
6.1.3.10
Assemble sliding sleeve assembly to floating plate assembly using clevis pins and
cotter pins. See Figure 8 & 9 for direction of clevis pins and positioning of cotter pins.
(For "SP" style clutches go to item #6.1.3.18)
6.1.3.11
For "C" style, install floating plate on hub and backplate assembly.
6.1.3.12
Assemble finger levers to adjusting ring using clevis pins and cotter pins. See Figure 8
& 9 for direction of clevis pins and positioning of cotter pins.
6.1.3.13
Assemble lever links, clevis pins and cotter pins to sliding sleeve. See Figure 8 & 9 for
direction & radius of clevis pins and positioning of cotter pins.
6.1.3.14
Bolt collar assembly to sliding sleeve.
6.1.3.15
Assemble sliding sleeve assembly to adjusting ring assembly using clevis pins and
cotter pins. See Figure 8 & 9 for direction of clevis pins and positioning of cotter pins.
6.1.3.16
Place spring & adjusting lock pin into adjusting ring. Retract pin and put a wire (paper
clip) through the pin hole.
6.1.3.17
Screw adjusting ring assembly onto hub threads to secure floating plate.
6.1.3.18
Brush anti-seize lubricant on shaft for easy assembly.
6.1.3.19
Place key into keyway on shaft.
6.1.4
INSTALL CLUTCH PACK
6.1.4.1
Align keyway with key in shaft.
***IMPORTANT***TURN ENGAGEMENT SHAFT TO ALIGN FORKS WITH BALL BEARING COLLAR AS
CLUTCH IS POSTITIONED ONTO SHAFT SEE
Figure 10
Figure 10
6.1.4.2
Slide clutch pack onto shaft.
6.1.4.3
Install lock washer on shaft next to hub, make sure tab is located in hole.
6.1.4.4
Install lock nut on shaft making sure direction is as shown on drawing and torque nut
(See Appendix A).
6.1.4.5
Bend lock washer onto one flat of clutch nut.