MPS-4
World Precision Instruments
5
12. Connect the stainless holder rod to the µ-manifold. The end of the holder rod is
a male luer fitting. It can be pressed into the center hole of the µ-manifold for a
secure hold. Fix the holder to a micromanipulator.
TIP
: We recommend WPI’s
KITE-L
for this purpose. It has sufficient precision for
the perfusion tip and an economical price. It has a left hand scale for placing on
the left side of the microscope, leaving the right side free for the patch pipette.
13. Connect the
MPS-4
to a computer USB port.
14. Connect a cable with a BNC plug to the socket on the back panel of
MPS-4
controller corresponding to the channel to be controlled. Connect the other end
of the cable to the equipment that generates the control signal.
OPERATING INSTRUCTIONS
Fig. 3—The front panel of the MPS-4 has the operational controls.
The left section of the
MPS-4
front panel contains the
Start
,
Reset
and
Mode
buttons,
and three functional indicator LEDs.
Start
button–The button runs the perfusion process. In the Online mode,
it acts as the
button and runs the experiment controlled by the
perfusion software. In Offline mode, the
Start
button runs the preset
perfusion parameters saved to the RAM of the control box from the
computer.
Reset
button–This button is the zero button for the micro-controller. It
stops any currently running experiment, turns all channels off and resets
the mode to Manual. Press the button and hold it for 1 second before
lifting it to ensure the system is completely reset.
Mode
button–This button toggles the perfusion mode between Manual,
Online, Offline and Master Manual. Once a mode is selected, the
corresponding LED illuminates. In Master Manual mode, the Manual LED
blinks continuously.
Summary of Contents for MPS-4
