WPI ATC2000, Instruction Manual

Page: 13 / 24

ATC2000
World Precision Instruments 9
NOTE : If the unit is placed in adaptive mode, then the heater plate is not available
as a temperature source option here.
3. To make the selected temperature source the default temperature source,
press the
SRC
button again. A *D* appears on the display next to your choice to
indicate that it is the default temperature source. The unit will retain the default
setting even after you power off the ATC2000 .
Fig. 9—The *D* appears next to the Thermocouple temperature source to indicate that the
thermocouple is the store default temperature source.
4. Press the Display button to save the new temperature source.
Setting Configuration Parameters
Press the Config button on the ATC2000 to access the Configuration menu. From this
menu, you can:
• Adjust the set point temperature
• Set the high and low alarm limits
• Enable/disable the audible alarm
• Adjust the three temperature offsets
Setting Temperature Set Point
1. Press the Config button to access the Configuration menu. The temperature set
point displays. The default is 37°C.
Fig. 10—The set point can be adjusted with the Up/Down buttons.
2. Press the Up or Down key to change the set point. The controlled temperature
range can be adjusted up to 45°C.
3. Press the Display button to save the new parameters or press the Config button
to toggle through the rest of the parameters.
Setting High Alarm Limit
If the controlled temperature climbs above the high alarm temperature limit, the
Sensor Alarm LED illuminates. If the audible alarms are enabled, the ATC2000
will also beep continuously until the
temperature falls back into the acceptable
range. See “Enabling Audible Alarm” on
page 10.
1. Press the Config button on the ATC2000 to access the Configuration menu.
Press the Config button again until the High Alarm Limit parameter displays.
Fig. 11—The high alarm limit parameter can be adjusted with the Up/Down buttons.