Rev 4.0/8-17
14
N4950/N10TAIR: #35105
5
4
3
2
1
T
O
R
EPLACE
S
EALING
R
ING
I
NSERT IN
VPFS10T
P
ADS
If the lifter is equipped with VPFS10T vacuum pads,
replace the sealing ring insert (see REPLACEMENT PARTS
LIST) as shown:
1) Remove the old sealing ring insert.
Make sure the entire vacuum pad is clean, including
the mounting groove (see V
ACUUM
P
AD
M
AINTENANCE
:
Pad Cleaning preceding).
2) Place the inside edge of a new sealing ring insert
against the inside edge of the mounting groove.
3) Push the sealing ring insert into the mounting groove,
beginning in 4 locations as shown.
4) Push gently and firmly on the outside edge of the ring
insert until its base (flat side) fits flush against the
bottom of the mounting groove. A pad ring installation
tool is available to facilitate this process (see
REPLACEMENT PARTS LIST).
5) Make sure that the sealing ring seats completely and
securely in the mounting groove, around the entire
perimeter of the vacuum pad.
Note: If the ring insert ever comes partially or entirely out
of the mounting groove, inspect the ring insert for
damage and reinstall an undamaged ring insert according
to preceding directions.
Summary of Contents for N10TAIR
Page 2: ......
