![WPG MT1010TDC Operating Instructions Manual Download Page 15](http://html1.mh-extra.com/html/wpg/mt1010tdc/mt1010tdc_operating-instructions-manual_999810015.webp)
Rev 17.2/12-21
MT-10TDC-HV-C: #35094
13
Checking the Battery
Always check battery energy before
every lift.
Use the battery gauge to determine whether the battery needs to be charged (see
).
1
Never use the lifter unless battery energy appears in the green range.
• While the power switch is in the “on” position (
), the battery gauge automatically
shows battery energy.
2
• While the power switch is in the “off”
position (
), use the battery test
button (circled) to check the battery
energy.
3
1..... If the vacuum pump is running or the battery charger is connected to an AC power source, the battery gauge will shown an inaccurate energy
level.
2..... After the pump stops running, the battery gauge requires a few moments to stabilize before it shows an accurate energy level.
3..... If the lifter has not been used since the battery was charged, the battery gauge may falsely show a high energy level. This “surface charge”
dissipates after the pump runs for about 1 minute, allowing the gauge to show accurate energy.
OPERATION