Worx WX852, Manual

Page: 4 / 16

4
EN
12V Multifunction Jump Starter
with LED Lights
GENERAL SAFETY WARNINGS
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
- This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.
- Children should be supervised to ensure that they
do not play with the appliance.
ADDITIONAL SAFETY
INSTRUCTIONS FOR JUMP
STARTER
1. Do not use the unit for works other than those for
which they are designed.
2. Do not disassemble the unit and keep it out of the
reach of children.
3. Do not expose to rain or get wet.
4. Do not short out the contacts of Jump Starter.
5. Do not charge the Jump Starter with a damaged
wall charger or power extension cord. Replace
them immediately.
6. When using, ensure that the product is in a
well-ventilated area and away from inflammable
materials.
7. Batteries can get hot during charging. Do not
overcharge any batteries. Ensure that Jump starter
are not left unsupervised during charging.
8. Protect the product away from fire and heat, such
as sunlight, or car and trunk in summer.
9. Please use the specified charger (cable) for
charging. If the product or cable is damaged,
please do not use the product.
10. Do not disassemble, bump, squeeze, puncture or
penetrate the product.
11. Keep jump starter dry, clean and oil-free. Be sure to
use a clean cloth when cleaning and do not use any
corrosive solvent.
12. Longer life and better performance can be
obtained if the battery is charged when the air
temperature is between 18°C and 24°C. Do not
charge the battery in air temperatures below 0°C,
or above 40°C. This is important as it can prevent
serious damage to the battery.
13. Do not recharge non-rechargeable batteries, as
they can overheat and break.
ADDITIONAL SAFETY
INSTRUCTIONS FOR USING
AS JUMP STARTER
WARNING: The POWERLIGHT RESCUE should
only be used as a jump starter with the supplied
Safety Cable. NEVER use an alternate cable when
jump starting with the POWERLIGHT RESCUE
1. Someone should always be within range of your
voice or close enough to come to your aid when
you work near a lead-acid battery.
2. Have plenty of fresh water and soap nearby in
case battery acid contacts skin, clothing or eyes.
Protective eyewear should always be worn when
working near lead-acid batteries.
3. If battery acid contacts skin or clothing, wash
immediately with soap and water. If acid enters
eye, immediately flood eye with running cold water
for at least 10 minutes and get medical attention
immediately.
4. Be extra cautious to reduce risk of dropping a
metal tool onto a battery. It might spark or short
circuit the battery or another electrical part that
may cause explosion.
5. Remove personal metal items such as rings,
bracelets, necklaces and watches when working
with a lead-acid battery. A lead-acid battery can
produce a short-circuit current high enough to
weld a ring or the like to metal, causing a severe
burn.
6. Use the jump starter for jump starting lead-acid
batteries only. Do not use for charging dry-cell
batteries that are commonly used with home
appliances. These batteries may burst and cause
injury to persons and damage to property.
7. NEVER charge or jump start a frozen battery.
8. To prevent arcing, NEVER allow clamps to touch
together or to contact the same piece of metal.
9. Do not disassemble, bump, squeeze, puncture or
penetrate the product.
10. Keep jump starter dry, clean and oil-free. Be sure to
use a clean cloth when cleaning and do not use any
corrosive solvent.
SAFETY WARNINGS FOR
BATTERY CELLS INSIDE THE
TOOL
a) Do not dismantle, open or shred cells.
b) Do not short-circuit charging terminal. Do
not store power tool haphazardly in a box or
drawer where charging terminal may short-
circuit each other or be short-circuited by
conductive materials. When power tool is not
in use, keep it away from other metal objects, like
paper clips, coins, keys, nails, screws or other small