Worx WX646, Safety And Operating Manual

Page: 3 / 16

Palm sander WX646 WX646.1
4. PoWeR tool USe AND cARe
a)
Do not force the power tool. Use
the correct power tool for your
application.
The correct power tool will do
the job better and safer at the rate for which
it was designed.
b)
Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c)
Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools.
Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
d)
Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power tool
or these instructions to operate the
power tool.
Power tools are dangerous in
the hands of untrained users.
e)
Maintain power tools. check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool’s operation. If damaged, have the
power tool repaired before use.
Many
accidents are caused by poorly maintained
power tools.
f)
keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g)
Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed.
Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5. SeRvIce
a)
Have your power tool serviced by
a qualified repair person using only
identical replacement parts.
This will
ensure that the safety of the power tool is
maintained.
Safety WarningS
Common for Sanding
oPeration
a)
this power tool is intended to
function as a sander. Read all safety
warnings, instructions, illustrations
and specifications provided with
this power tool.
Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious injury.
b)
operations such as grinding, wire
brushing, polishing or cutting-off are
not recommended to be performed
with this power tool.
Operations for
which the power tool was not designed
may create a hazard and cause personal
injury.
c)
Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer.
Just because the accessory
can be attached to your power tool, it does
not assure safe operation.
d)
the rated speed of the accessory
must be at least equal to the
maximum speed marked on the power
tool.
Accessories running faster than their
rated speed can break and fly apart.
e)
the outside diameter and the
thickness of your accessory must
be within the capacity rating of your
power tool.
Incorrectly sized accessories
cannot be adequately guarded or
controlled.
f)
the arbour size of wheels, flanges,
backing pads or any other accessory
must properly fit the spindle of the
power tool.
Accessories with arbour holes
that do not match the mounting hardware
of the power tool will run out of balance,
vibrate excessively and may cause loss of
control.
g)
Do not use a damaged accessory.
Before each use inspect the accessory
such as abrasive wheels for chips
and cracks, backing pad for cracks,
tear or excess wear, wire brush for
loose or cracked wires. If power tool
or accessory is dropped, inspect